Prusa MK2s Raspberry Pi V2 Camera Holder

I wanted a design that would do a better job hiding the raspberry pi camera cable. This design routs the cable downward through the body and base, and then has a cable holder you can glue on to send the cable towards the back of the printer. You still end up with the cable loose under the bed, because there's no way around that, but it's at least a little neater than the other designs I've seen because it stays nicely under the bed

I also wanted a design that wouldn't move and didn't have any parts that would wear out, and I was willing to give up a few axis of freedom to achieve that. This design gives you full control over the yaw, rough control over the height, but no control over the pitch/roll.

Also, this isn't strictly a remix but it is based on the design of the following camera mount:
https://www.thingiverse.com/thing:2352964