Prusa Parts

Various parts that I have printed to fit my printer. Im not sure on what design my X carriage is, so Ive been measuring and then adjusting to fit.

Yendstop: The holes are at 19mm to fit a makerbot endstop.
New version of endstop bracket (differnt to photo): about 4mm lower to accommodate a thinner build plate that im now using, thickened some places, and now printing it on its side using support.
Modified bar clamp: hole is bigger to slide on easier. also beefed it up a bit.
Fan Mount: Has to be printed in two halves and then glued together. I increased the surface area that contacts the build plate to prevent lifting. The mesh is messy where those tabs are, but it slices correctly.
Zend stop servo bracket: Nothing special.
Light bar: just for stick on strip leds