Thingiverse
Prusa Spool holder
door nbesselsen
0
Downloads
1
Likes
0
Makes
This is a spool holder that uses the original holder that comes with the Prusa I3 MK3S
I designed this because I did not want to drill extra holes in my wall.
The part are bolt on and do not require any tools except for an allen key. The original spool holder just slides on the new one and stays in place by friction and when there is a spool hanging it’s not going anywhere .
*The print volume is reduced a bit in the Z direction because it sticks out in front of the frame. I might redesign it to counter that, but that is for the future.
Materials needed:
4X M5X12mm
4X M5 nut
4mm allen/hex key
12,5M / 38gr of 1.75mm filament
Total print time: 4,5H
I designed this because I did not want to drill extra holes in my wall.
The part are bolt on and do not require any tools except for an allen key. The original spool holder just slides on the new one and stays in place by friction and when there is a spool hanging it’s not going anywhere .
*The print volume is reduced a bit in the Z direction because it sticks out in front of the frame. I might redesign it to counter that, but that is for the future.
Materials needed:
4X M5X12mm
4X M5 nut
4mm allen/hex key
12,5M / 38gr of 1.75mm filament
Total print time: 4,5H
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
