Thingiverse
PS Eye Tripod Shoe
45
Downloads
19
Likes
1
Makes
A shoe for the ps eye camera.
!!IMPORTANT!!
I added a feature that the camera can only go in by one way. It should stop it from falling out.
Just heat the threaded rod a bit and then drill the thread into the hole on the bottom.
I suggest to print this upside down to have the minimal amount of overhang.
And add some tape or something on the bottom inside the shoe to tighten the camera.
Enjoy!
!!IMPORTANT!!
I added a feature that the camera can only go in by one way. It should stop it from falling out.
Just heat the threaded rod a bit and then drill the thread into the hole on the bottom.
I suggest to print this upside down to have the minimal amount of overhang.
And add some tape or something on the bottom inside the shoe to tighten the camera.
Enjoy!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
