Thingiverse
PS Move DIY VR Headtracker
door Nanafalke
11
Downloads
14
Likes
0
Makes
This is an enclosure for a VR Headtracker from DaleyTech (https://www.youtube.com/watch?v=pGP1qxwR1Lc).
You need:
1 PingPong Ball
8 Ohm resistor
battery holder (2xAA)
Wires
Switch
LED (http://r.ebay.com/GLVlNe)
Printed case and lid
Put a switch into the case, solder the positive wire to it and connect it with the 8 Ohm resistor to your led. Then add ground and solder it to the led. Drill a hole into your ball matching the size of the LED. Glue the LED into the lid and the ball from above. Close the lid and you are done.
For software setup, watch the video on DaleyTechs Channel.
You need:
1 PingPong Ball
8 Ohm resistor
battery holder (2xAA)
Wires
Switch
LED (http://r.ebay.com/GLVlNe)
Printed case and lid
Put a switch into the case, solder the positive wire to it and connect it with the 8 Ohm resistor to your led. Then add ground and solder it to the led. Drill a hole into your ball matching the size of the LED. Glue the LED into the lid and the ball from above. Close the lid and you are done.
For software setup, watch the video on DaleyTechs Channel.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
