PS4 Slim Wall mount

This wall mount was inspired by FM-I's design: https://www.thingiverse.com/thing:2586880

I really liked the design of that one, however it didn't fit on my printer. I also didn't like that it was visible from the top and that you needed to remove the rubber feet.
I wanted to make a nearly invisible mount that was secure and aesthetically pleasing.

I made sure none of the fan intakes and exhausts get blocked.

Hardware you will need:
- 5 countersunk screws for your wall
- One M3×20 screw with a flat head

Installation:
1. Mark the locations of the holes according to the measurements (in mm) from the image above.
2. If you are drilling into a concrete wall I recommend countersinking the holes first so the bit doesn't skip around. The holes need to be very exact.
3. Please make sure there are no wires running through the wall where you are planning to drill.
4. Drill the holes and screw the brackets to the wall. Make sure the screwheads are flush
5. Slide your PS4 slim i