Thingiverse
PSA Dagger Mag Sleeve
von abc3168
52
Downloads
59
Likes
0
Makes
Pmag Sleeves, Fit 27 and 21 Style Pmags, with cutouts to fit PSA Dagger (Will not fit Dagger S) "Airsoft Pistols"
I made these to fill out the really slim look the extended Pmags have.
-Sleeves are Friction fit
-Both Sleeves will allow mag a little wiggle room similar to factory (21 Might have a little extra, was pretty tight at the top, shortened a tiny bit, and have not got a chance to test print another)
-Print Sleeves Upright
-Print Baseplate with Back flat on Printbed
I made these to fill out the really slim look the extended Pmags have.
-Sleeves are Friction fit
-Both Sleeves will allow mag a little wiggle room similar to factory (21 Might have a little extra, was pretty tight at the top, shortened a tiny bit, and have not got a chance to test print another)
-Print Sleeves Upright
-Print Baseplate with Back flat on Printbed
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
