Thingiverse
PSU Bracket (Black PSU)
von MrALF
59
Downloads
38
Likes
0
Makes
Very basic PSU Bracket for the MK3S Black PSU.
With my lack stack against the wall I ran into trouble with the suggested mounting of the PSU, either the switch and power connector were unreachable or the air vents of the PSU were facing the wall.
So I switched from mounting the PSU to the leg to mounting it on the underside of the table.
The standard cable length is adequate.
Requires 4 screws in total (The PSU itself has 2 mounting slots near the terminals)
This is the first step in bringing the power switch and light switch to the front of the enclosure.
With my lack stack against the wall I ran into trouble with the suggested mounting of the PSU, either the switch and power connector were unreachable or the air vents of the PSU were facing the wall.
So I switched from mounting the PSU to the leg to mounting it on the underside of the table.
The standard cable length is adequate.
Requires 4 screws in total (The PSU itself has 2 mounting slots near the terminals)
This is the first step in bringing the power switch and light switch to the front of the enclosure.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
