PSU cover mount

Marked WIP, for in case of if more ventialtion are needed other than the slots in the front and the other half of the lid.

EDIT: Noticed that the hole for the fan were missplaced and there were a few screwholes to many on the lid.

This is made to work together with this https://www.thingiverse.com/thing:3266284

Works with powersupplies with a max/ width 110mm, 220mm length and 50mm hight.

If you wish to screw it to the bottom the holes are 4mm diameter and 85x126mm.

The lid is split in two so that you dont need to remove all 8 screws if you need to manage cables.

If you are using the junktionbox linked at the top all you need to do is put them flush together as the slots for the cables match.