PSU Cover

PSU COVER 3D PRINTER
=====================

Shamelessly cloned from [Tevo Tarantula PSU Cover](https://www.thingiverse.com/thing:2518780), but made from scratch. 3D files attached, if someone wants to remix again.

**NEEDED PARTS**

* 3x [XT60 connectors](https://www.banggood.com/5X-XT60-Male-Female-Bullet-Connectors-Plugs-For-RC-Battery-p-916559.html)
* 1x [IEC 320 C14 Red Light Rocker Switch Fuse Inlet Male Connector Plug](https://www.globalsources.com/gsol/I/DC-power/p/sm/1166344475.htm#1166344475)

**INSTRUCTIONS**
1. The 3 pin plug needs two M4 screws of at least 6-8 mm long and 2 nuts.
2. The slot for the TX60 connectors is tight enough to hold them in place but just in case I superglued them to the walls.
3. To hold the cover in place screw 3x M4 screws through the hole on the left/right sides to the hole on the PSU.