Thingiverse
PSU Tester replacement case
door sarahdragon
0
Downloads
0
Likes
0
Makes
I had an old PSU tester, like the one in the photo.. it had that 'soft' rubbery coating and it went yuck... all sticky to touch.. so I designed a 3D printed replacement
The replacement is smaller than the original and uses the same screws, so you don't have to find anything else.. just take the four screws out from your old one, remove the PCB and place it into this new case, use the same 4 screws to close this up.
I included a photo of the front of the old tester, that I printed out and stuck onto my new tester, just so I know what lights do what.
two stl files, print without any drama..LEDs may need a bit of manipulating to get them into the holes, but they do all fit nice and snug.
Photos of the old sticky case.. the new case just printed and assembled and with the printed sticker on thje front..
The replacement is smaller than the original and uses the same screws, so you don't have to find anything else.. just take the four screws out from your old one, remove the PCB and place it into this new case, use the same 4 screws to close this up.
I included a photo of the front of the old tester, that I printed out and stuck onto my new tester, just so I know what lights do what.
two stl files, print without any drama..LEDs may need a bit of manipulating to get them into the holes, but they do all fit nice and snug.
Photos of the old sticky case.. the new case just printed and assembled and with the printed sticker on thje front..
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
