PTFE 2 in 1 Adapter

I wanted more strength lengthwise and minimal supports (I built them in) as well as a modified filament path and printed in halves to keep pathways clean and precise to minimize drag. It's designed for a PC4-M10 bowden connector with a 10mm thread, a 6mm inner diameter, and a 4mm core diameter (pic included). I set mouse ears around the 6 support pieces. Printed at .12 layer height it takes just over an hour. I print mine in ASA just for more toughness. PLA would probably be fine. Do a quick trim of the 3 alignment holes and pop it together. Put the reinforcement rings on both ends to hold it together (no glue needed) and screw in the bowden connectors.