Thingiverse
PTFE Cap / Endplug
door MakerMeik
12
Downloads
10
Likes
0
Makes
The filament box from XrControl has convinced me very much.
Check out his video about it. Unfortunately, it is only available in German: https://www.youtube.com/watch?v=6-2agpkSxcs.
However, you need two PTFE couplings for it. Since I wanted to save the second coupling, I constructed this end plug.
So that the filament is not completely pushed back into the tube, it can be put into the cap beyond the notch. The PTFE, on the other hand, is only pushed to the notch. Thus, the filament remains within reach after opening the cap.
The cap can be printed without supports. It is best to use TPU.
Check out his video about it. Unfortunately, it is only available in German: https://www.youtube.com/watch?v=6-2agpkSxcs.
However, you need two PTFE couplings for it. Since I wanted to save the second coupling, I constructed this end plug.
So that the filament is not completely pushed back into the tube, it can be put into the cap beyond the notch. The PTFE, on the other hand, is only pushed to the notch. Thus, the filament remains within reach after opening the cap.
The cap can be printed without supports. It is best to use TPU.
MakerMeik publiceert ook op
53 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
