Thingiverse
PTFE Tube Fitting Passtrough Heat Insert
von drops77
2
Downloads
0
Likes
0
Makes
Only changed the depth/hole to allow a heat insert. Not the best design ,but needed it quick.
I ended up using this for my Vcore printer since the wall was too thin to support both ends of the PTFE tube.
Parts needed:
M3 6*5 heat insert
M3x 20mm (depends on your wall depth.
I ended up using this for my Vcore printer since the wall was too thin to support both ends of the PTFE tube.
Parts needed:
M3 6*5 heat insert
M3x 20mm (depends on your wall depth.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!