MakerWorld
Hueforge & Lithophane
Go to Model
Pug cute hueforge
97
Downloads
45
Likes
45
Makes
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 200x200mm in sizeYou may print at higher layer heights below the Min Depth of 0.48mmThe Max Depth is 2.2mm and the Actual Depth is 2.2mmFilaments Used: PLA Smartfil negro PLA BambuLab Basic Gray PLA Smartfil blanco Boost Megracias por apoyar mi contenido 😍😍This print uses 3 unique filamentsSwap Instructions: Start with negro At layer #10 (0.88mm) swap to Gray At layer #19 (1.6mm) swap to blanco for the rest.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
