Pull-Relief for 6 mm Cable

This pull relief is made for 6 mm cables (antenna cable in my case).
Print it with 0.1 mm layer height and everything should work fine.

bruncedric relesed thing:5262888, which is very similar. His "cable screw conector" is for a greater variety of cables. Check it out!
I needed it a lot smaller and as bruncedric didn´t allow derivates, I had to draw everything from scratch. I will use two of mine to build an 1800 Mhz-LTE-Antenna.

Use Freecad to modify/remix it.