Thingiverse
Pull Up Bar Brackets
0
Downloads
2
Likes
0
Makes
A pull-up bar holder created with generative design for a 1" iron pipe using Fusion 360.
For thinner pipes, you can print from TPU material by designing the damper part that goes inside the outer plastic frame in different diameters. This material is also successful in damping sudden loads affecting the body. Therefore, I do not recommend using another material instead of TPU. But if you do, it will still work without any major problems.
I printed the entire body using ABS or PLA material with 3 layers of outer wall and 100% infill.
You can write your requests and feedback in the comments section, I will check from time to time and get back to you.
For thinner pipes, you can print from TPU material by designing the damper part that goes inside the outer plastic frame in different diameters. This material is also successful in damping sudden loads affecting the body. Therefore, I do not recommend using another material instead of TPU. But if you do, it will still work without any major problems.
I printed the entire body using ABS or PLA material with 3 layers of outer wall and 100% infill.
You can write your requests and feedback in the comments section, I will check from time to time and get back to you.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
