Thingiverse
Pulsar pier opening cover
door FabriceF
0
Downloads
0
Likes
0
Makes
The Pulsar pier has an access opening on the side to allow the mount to be screwed from underneath.
I found this opening a little unsettling because anything falling at the bottom of the pier would be difficult to retrieve! It's unlikely but accidents happen!
So I created this cover. You'll need to purchase cabinet magnets and stick them to the inside of the cover with strong double-sided tape.
Standard magnets are 41 x 16 mm.
The cover is designed for a 172.5 mm diameter pier and a 90 x 90 mm opening.
I found this opening a little unsettling because anything falling at the bottom of the pier would be difficult to retrieve! It's unlikely but accidents happen!
So I created this cover. You'll need to purchase cabinet magnets and stick them to the inside of the cover with strong double-sided tape.
Standard magnets are 41 x 16 mm.
The cover is designed for a 172.5 mm diameter pier and a 90 x 90 mm opening.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!