Pump Handle Accessory (PHA) for CCI Phantom 4"

This is the now updated v04 grip 'Pump Handle Accessory' (PHA) for a CCI Phantom paintball marker 4" or 2 1/2" pump handle. Its three pieces that snap together onto the stock pump handle to help it feel similar to an undercooking kit. The tolerances are designed for makerbot pla filament. The new design now screws together.

For the 4" handle: there are now 2 options for the middle section, either straight or with ridges for a better grip. You will need 2 x 10-24 1.5" socket head cap screws at least and 2 x 10-24 square nuts. The nuts drop into the 2 recesses in the middle section and the socket screws go into the ends to tighten it. up.

**NEW** For the 2 1/2" handle: There is now a short middle section that works with the ends. You will need 2 x 10-24 7/8" socket head cap screws and a 10-24 x 3/4" Hex Coupling Nut. The coupling nut drops into the middle section and the ends screw into it. Please note that I don't have a 2 1/2" handle, so this hasn't been tested yet. If you print