Pumpkachu Pokéball

A cute and spooky twist on a Pokeball for Halloween. Instead of the traditional top of a Pokéball, this is a pumpkin shaped spin-off with Pikachu. Who doesn't love Pikachu? This was based off of the two models listed so check them out.Printing Settings:Support OnTree AutoOn build plate onlyBrim is used2 skirt loop (Loop # is up to you)Outer and inner brimAssembly: (Full description on RC3D's page so take a look)"The assembly is done by first gluing the top shell and bottom shell to the pokeball internals. Once the glue is dry, slide a small piece of filament through the hinge while holding the two halves together. Cut the ends flush to the pokeball, and add a drop of glue to the outside pieces of the filament since the center hinge piece is the only one that needs to rotate in order to operate. Finally, glue the button onto the pokeball. If the filament piece used for the hinge is tight, you might have to take an allen key and hollow out the hole a bit to get it to slide in