Pumpkin K-Cup Holder

This is a k-cup holder I designed to spice up my counter and to put a little fall atmosphere in the house. Ideally it would be pumpkin colored but I only had grey filament so I'll just have to paint it.

Stores up to 9 cups at a time. Lip inside that will lock the top part of the pumpkin in place

Must be printed no smaller than original size for the cups to fit right

If you would like to support me or sell printed out versions of this ghost check out my patreon: https://www.patreon.com/c/bigtaterprinting/posts

Do not print this faster than 124% speed! It will cause quality issues. This design you can get away with a rather low infill. Supports are necessary for bottom. Infill pattern does not matter.