Pumpkin Stitch

Aloha,I made a Stitch Jack o'lantern pumpkin light, designed to fit a standard LED tea light.I was inspired by a Stitch pumpkin that used to be in Tokyo Disneyland, and it was later released as a limited-edition pin from the Disney store in 2016.Coloured version infoI printed it in Basic Orange (10300), Basic Yellow (10400), and Matte Grass Green (11500). During the print, the purge tower and a support got loose. So I do recommend setting the heat bed temperature a bit higher. On my coloured version i also noticed some very visable lines. Im not entierly shure why, but i di pause the print a couple of times. So that may have been the cause. My single colour orange version came out much cleaner. Boost MeIf there is an interest. I may also make an alternative angel version in the same style.This is actually my second attempt. The first one was when i had just started learning 3d modeling. I've grown a lot since then. I'm nowhere near a professional. This time, I felt proud en