Thingiverse
Push Block
von CliffGlanz
1.4k
Downloads
809
Likes
3
Makes
3D Push Block for wood working.
Print all parts. Only the Main Body need supports in the hex area. All other parts print with no supports if oriented properly.
Glue 1/4"-20 nuts into the hex openings on the main body & skinny legs. I used Hillman brand nuts and screws purchased at HomeDepot. The nuts are 0.185" thick. Glue something very grippy to the bottom of the Center Legs and skinny legs. I used Drywall sanding pads and super glue.
Main Body = 1
Center Leg=1
Leg=2
Handle=1
Oval Washer=4
ThumbScrew=2
Push Heal = Optional
Print Settings:
2 Walls
2 Top
2 Bottom
20 % infill
Print all parts. Only the Main Body need supports in the hex area. All other parts print with no supports if oriented properly.
Glue 1/4"-20 nuts into the hex openings on the main body & skinny legs. I used Hillman brand nuts and screws purchased at HomeDepot. The nuts are 0.185" thick. Glue something very grippy to the bottom of the Center Legs and skinny legs. I used Drywall sanding pads and super glue.
Main Body = 1
Center Leg=1
Leg=2
Handle=1
Oval Washer=4
ThumbScrew=2
Push Heal = Optional
Print Settings:
2 Walls
2 Top
2 Bottom
20 % infill
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
