Push Button Cap for 6×6mm Tactile Switch

📝 Overview
This model is a two-part push button cap designed for 6×6mm tactile switches.
Tactile switches can be hard to press and may hurt your fingers when used directly, so this cap provides a larger, more comfortable surface. It’s especially designed to be easy for children to press.

🔧 How to Use
Solder wires to your tactile switch in advance.

Insert the switch into the bottom part of the cap and route the wires out through the side hole.

With the button facing upward, align the switch in the center and secure it lightly with masking tape or glue.

Snap the top part onto the base by aligning the clips—done!

📐 Compatible Switch
Designed for standard 6×6mm tactile switches.

🖨️ Recommended Print Settings
Material: PLA (others should work fine)

Layer height: 0.16mm

Supports: Minimal required

Infill: 100%

💡 Notes
The fit is designed to be snug, so some pressure may be needed during assembly.

The simple design makes it easy to modify or resize as needed.