Thingiverse
push-open spring mount for wardrobe
por ozfunghi
5
Descargas
3
Likes
0
Makes
Needed a mount for the push-pull spring mechanisms for my closet/wardrobe. The cilinders of the mechanism are 80mm long and 10mm wide. However, i made the hole 11mm wide, because the bottom tip of the mechanism is not an exact fit. So you will probably need to wrap some tape around the spring mechanism to make it fit snugly. Or if you want, you can resize the x and y axis in your slicer a bit.
Normally you have to drill holes into the shelves for the mechanisms to slide into, but our shelves weren't thick enough, so i needed a mount for the mechanism.
You should be able to print this without supports.
Normally you have to drill holes into the shelves for the mechanisms to slide into, but our shelves weren't thick enough, so i needed a mount for the mechanism.
You should be able to print this without supports.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
