Thingiverse
"PUSH" sign.
von alexnettles
0
Downloads
1
Likes
0
Makes
For buttons, doors, limits, issues, etc.
150mm x 211.5mm x 2mm
w.gap.stl models were designed to perfectly adorn a pair of commercial doors that had an 11.5mm gap between the mounting surfaces. If I had used the other models that I included the letters would have been spread out too far and it would have looked dumb. However I went back and constructed a "complete" sign for you. I have split that one down the middle, and included the results of that too (PU.stl and SH.stl).
150mm x 211.5mm x 2mm
w.gap.stl models were designed to perfectly adorn a pair of commercial doors that had an 11.5mm gap between the mounting surfaces. If I had used the other models that I included the letters would have been spread out too far and it would have looked dumb. However I went back and constructed a "complete" sign for you. I have split that one down the middle, and included the results of that too (PU.stl and SH.stl).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
