Thingiverse
Push-up Bars with Carpet Grip
door willbert6100
8
Downloads
6
Likes
0
Makes
I needed some push-up bars that would grip my carpet while exercising. I was doing push-ups normally but having my hands flat on the ground were hurting my wrists. Not going to lie I was worried about the strength of these things but I was able to do a push-up with both hands on one bar in the center with no discernible flexing, at 40% infill (I weigh about 250lbs). Note that at 40% infill they take a little while to print out but it prints easy without supports.
Update #1: I broke one of these while using them, it broke right down the middle, so I recommend increasing wall/shell count.
Update #2: Changed the rounds to chamfers to make printing without supports easier.
Update #1: I broke one of these while using them, it broke right down the middle, so I recommend increasing wall/shell count.
Update #2: Changed the rounds to chamfers to make printing without supports easier.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
