Push Up Knife

This is a knife i designed that can be slid in and out of the handle. I found that the print worked better when scaled up to around 140%, this just makes it so the pins print stronger.

For the handle I would recommend an infill of around 50 or higher to ensure strength with it, the blade doesn't matter but for the pins, print in 100% infill.

When printed, to asseble it is very easy, all you have to do is take the blade and line up the guideline with the one inside the handle and insert into handle. Once the blade is inserted, take the pins and put them through the holes in the blade lining up with the lines on the handle.

If you have any issues or changes to make just add to the comments and ill do my best to keep up.