Pusher Breech for Buzz Bee Snipe

This is a pusher breech designed for the Buzz Bee Snipe, to install you must first remove all non-crucial internals, then drop the muzzle piece in place (the hole goes right over the dart gate's post) and screw it in with the screw that was there before. To install the pusher you need to cut the original breech down by roughly 70mm (my dart tooth was broken off of mine). While the piece should friction fit in, it may need some slight sanding at the end, and I put a thin layer of E-tape up at the front to ensure a good seal.

For the O-ring I used a spare from the Nexus Pro stock, I wouldn't recommend anything larger than that because its a pretty tight seal with that one.

You can also friction fit whatever type of barrel the Nexus Pro uses into the front of the muzzle, I recently brassed mine so I figured why not, however I would recommend upgrading the spring for that, as the stock spring gets increased velocities out of the breech alone, but with the Nexus barrel attached it suf