Thingiverse
Puzzle Cube Twisty
von 8orge
14
Downloads
8
Likes
0
Makes
This is a twisty cube puzzle 3x3x3 and the final size is
30x30x30mm it is tiny .
If you found this design very helpful or otherwise wish to support me ,you can buy me a cup of coffee ( helps keeping the brain active so i can create new stuff ) ;-) ,then please
consider using this link :
I have based it upon the original model witch have all the cubes
attached with a string/rubber-band ,but i decided to make the
entire cube printable with pegs instead and now it is a
print and play model .
If you find it very hard to assemble you can find very good
illustrations on the net about how to solve it .
I did not have any problems at all getting all the tiny cubes to
rotate after the printing ,and because i have chamfered all
the edges ,they will not get stuck to each-other.
First layer i did set to 0.24mm ,but that depends on how your printer
is set up , the rest of the layers is 0.2mm .
It is printed in golden pla at around 215-220 degrees and 70 degree
hot-bed
30x30x30mm it is tiny .
If you found this design very helpful or otherwise wish to support me ,you can buy me a cup of coffee ( helps keeping the brain active so i can create new stuff ) ;-) ,then please
consider using this link :
I have based it upon the original model witch have all the cubes
attached with a string/rubber-band ,but i decided to make the
entire cube printable with pegs instead and now it is a
print and play model .
If you find it very hard to assemble you can find very good
illustrations on the net about how to solve it .
I did not have any problems at all getting all the tiny cubes to
rotate after the printing ,and because i have chamfered all
the edges ,they will not get stuck to each-other.
First layer i did set to 0.24mm ,but that depends on how your printer
is set up , the rest of the layers is 0.2mm .
It is printed in golden pla at around 215-220 degrees and 70 degree
hot-bed
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
