Thingiverse
PVC End Cap for 2" PVC
von carrollca1
16
Downloads
11
Likes
0
Makes
End cap for 2" OD PVC Schedule 40 drain pipe. Not for pressure, just decorative.
Snug press fit.
If you need to seal it, place a ring of plumber's putty around the tip of the PVC pipe. Then smash this plug into the PVC pipe. For a good seal, make sure the putty squishes out.
Snug press fit.
If you need to seal it, place a ring of plumber's putty around the tip of the PVC pipe. Then smash this plug into the PVC pipe. For a good seal, make sure the putty squishes out.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!