Thingiverse
Music
Go to Model
PVC Organ Pipe
7
Downloads
8
Likes
0
Makes
PVC Organ Pipe. Made to fit 3/4" PVC pipe.
Look online for guides/calculators for sizing the pipe.
The lower and upper lip glue into place. Sand the flue and lower lip until it fits over the lower box section, and glue in place on the three sides.
For upper lip, have pipe installed (and capped if using as closed pipe) and blow into the bottom of the flue. Move upper lip up and down over the top part of the box until you get the sound you want, then mark and glue it to that spot.
The plug is for closed pipes. It is made a bit smaller than the pipe, so you can use some sort of cloth to make it a tight fit. Move the plug up and down until you have it in tune.
Look online for guides/calculators for sizing the pipe.
The lower and upper lip glue into place. Sand the flue and lower lip until it fits over the lower box section, and glue in place on the three sides.
For upper lip, have pipe installed (and capped if using as closed pipe) and blow into the bottom of the flue. Move upper lip up and down over the top part of the box until you get the sound you want, then mark and glue it to that spot.
The plug is for closed pipes. It is made a bit smaller than the pipe, so you can use some sort of cloth to make it a tight fit. Move the plug up and down until you have it in tune.
cadr also publishes on
1 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
