Thingiverse
PVC Spool Rack
von doguri
40
Downloads
26
Likes
0
Makes
Shelf that rests on the leg support of a Seville Classics UltraHD workbench.
Version 1: (Green in Photos)
Consists of two main supports, two 3/4 inch PVC pipe and 4 end caps.
The base slot on the support is 50mm wide and sits loosely on the leg support.
The pipe fittings are snug. Only the end caps were glued.
Version 2: (Blue in Photos.)
Supports are stackable.
The second beam is made from two printed brackets and two 1"x2" boards cut to 18 inches. The two boards are attached to the bracket using 1.25 in wood screws.
The beam support are two 1"x2" boards cut to 8.5 inches. The supports are attached to brackets and supports with 1in wood screws.
Version 1: (Green in Photos)
Consists of two main supports, two 3/4 inch PVC pipe and 4 end caps.
The base slot on the support is 50mm wide and sits loosely on the leg support.
The pipe fittings are snug. Only the end caps were glued.
Version 2: (Blue in Photos.)
Supports are stackable.
The second beam is made from two printed brackets and two 1"x2" boards cut to 18 inches. The two boards are attached to the bracket using 1.25 in wood screws.
The beam support are two 1"x2" boards cut to 8.5 inches. The supports are attached to brackets and supports with 1in wood screws.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
