Thingiverse
PVC Star corner connectors
von arcticgps
33
Downloads
17
Likes
0
Makes
Summary:
Print these corners and connect 1/5" PVC pipe to make a star shape. Wrap it with lights or stick on a light strip and you are good to go!
Instructions:
Print 5 outside corners at least. Cut your PVC pipe lengths to accommodate the size star you need. Weave the pipe to connect the corners or use 5 inside corners. I made a variant of the inside corners to allow a pipe to pass all the way through. Depending how you hang it, this provides much better support if you are making a relatively large star.
Use pan-headed screws with a flat bottom or you will split the connectors. You can also glue the connections for a permanent assembly.
Print these corners and connect 1/5" PVC pipe to make a star shape. Wrap it with lights or stick on a light strip and you are good to go!
Instructions:
Print 5 outside corners at least. Cut your PVC pipe lengths to accommodate the size star you need. Weave the pipe to connect the corners or use 5 inside corners. I made a variant of the inside corners to allow a pipe to pass all the way through. Depending how you hang it, this provides much better support if you are making a relatively large star.
Use pan-headed screws with a flat bottom or you will split the connectors. You can also glue the connections for a permanent assembly.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
