Thingiverse
PVC style corner pull with flange
by Noltz
5
Downloads
8
Likes
0
Makes
*** For Low Voltage uses only ***
This is a development of the ½" Pull Elbow commonly available in the electrical isle of your favorite home repair store. Printed in PLA it fits 1/2" PVC conduit to be used when surface mounting the PVC. It uses standard Carlon lids (E9990-D), or you can design your own.
3D printed components do NOT meet code as they melt at too low a temperature, so this is 100% for low voltage use only. Like, your insurance company might deny you if it causes the house to burn down, do it right and spend $20, kinda don't-do-it. But if you need to run your garage door opener, ethernet, or outdoor low-volt lighting and want a clean pass-through, enjoy!
This is a development of the ½" Pull Elbow commonly available in the electrical isle of your favorite home repair store. Printed in PLA it fits 1/2" PVC conduit to be used when surface mounting the PVC. It uses standard Carlon lids (E9990-D), or you can design your own.
3D printed components do NOT meet code as they melt at too low a temperature, so this is 100% for low voltage use only. Like, your insurance company might deny you if it causes the house to burn down, do it right and spend $20, kinda don't-do-it. But if you need to run your garage door opener, ethernet, or outdoor low-volt lighting and want a clean pass-through, enjoy!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!