Python AMS Large spool gear remix - 8 Spoke

A simple remix of the large gear used in the spool holders for the amazing Python AMS by Humebeam. I opted for a ‘wagon wheel’ 8 spoke design. This remix is faster to print and uses less material, however to my eyes is less aesthetically pleasing than the original. I also included angled holes to allow you to retain the end of the filament when not in use. The gears, fitting etc all remain the same so no impact on assembly. In my test the hole for the filament was fine as long as you have tuned your filament flow as instructed by humebeam in the original model listing. I can modify or add alternative hole sizes if needed. Thanks.