Q.F.C. e3d v6 mount

this mount will allow to precisely control the offset of the hotend in the y direction by lowering the A part in the slicer and using the lines in the left side as a reference ( lowering the piece until you are at the 4th line from the top will result in original offset )

this support will allow to use a lot of cooling ducts without modifications .
if you find a problem with your setup , a modified Part B usually will be all it takes to make the system work

the pieces must be printed in this way :
-The Part A needs no support and the big "MK V " must be on the bottom side
-The Part B needs support and must be printed with the "MK" on the bottom .
the little seams left by the support will usually be enough to grip the v6 a little better , this in conjunction with the serrations will , usually, allow to remove the v6 with the part B

all the screws are m3 and is possible to use a lot of length , the longer screws for Part A should be putted from the bottom side
the screw