Q Tip Holder

I tried printing the angled bottom version of this holder twice. with and without support. on both occasions my print looked terrible at the notch in front. The overhang was not printing as nice as I wished it would. In my case I decided to break the holder into 3 seperate pieces that would print without support of any kind. I left the lid alone. I then elongated the lid to act as a bottom tray, and added a notch in it. The body became a straight tube with a notch that can be printed notch up so there shouldnt be any support needed. I removed the printing on the front because the overhang was excessive and needed support. It could be added back on, and reduced to .5mm instead of the original 2mm, and it should print without support. I may do just that in the future.