Qanba Dragon USB C mod

I've adapted the recently posted Hori HRAP USB C mod to fit the Qanba Dragon arcade stick, as it would need internal modification to fit the depth of the original 3d print. Just like the HRAP the USB cables original hole is 8mm wide, so you need to shave off 0.5mm on each side to make this fit (test fitting the original cable you would not be able to tell, so it makes this mod entirely reversible without any signs that it was ever there. Go slow, use calipers to check the fit as you go).
The USB port used was from amazon (https://www.amazon.com/dp/B0B9N1S6SF?ref=ppx_yo2ov_dt_b_fed_asin_title), but I see no reason the Adafruit one probably works but these are what I had on hand, so your mileage may vary (Check the depth of the usb port itself).

To assemble I glued and clamped the USB port to both housings, if you feel like you want some extra support you can hot glue the assembled port in place, but it's more than likely unnecessary.