QAV 400 Dragonlink Receiver Bracket

This is a mounting bracket I printed off for my QAV400. The bottom plate has 2 sets of 4 holes which I think were originally intended for mounting landing gear, but otherwise go unused.

You'll need 4 - M4 nuts and screws. I purposely made the nut hole a little undersized because the nuts get melted in place to lock them in permanently. Use a soldering iron to heat the nut and press into place.

This mounting bracket was part of a series of modifications to relocate the UHF transmitter as far away from the other RF emitting sources. Scanning with a spectrum analyzer showed slightly better noise levels below the rig than above the rig which is what led to this being located where it is.

I've attached the SKP file in case you need to make any changes to it.

One other note - it's hard to make out in the photo but I soldered in a 300ma 5v step down regulator from Pololu into the power distribution board and routed the wires right to the bracket so you can power the receiver f