Qbrick System Tripod Holder

I needed a tripod mount for Qbrick System Pro crates, and the original mount for long objects turned out to be too narrow, so I designed this set.I used the original Qbrick connectors (photo), which I had the most of. And where did I get the ones on the left... ;)?The set consists of a top mount without a bottom (pass-through), a bottom mount (with a bottom), and four end caps.Internal dimensions are approximately 63x63 mm.The end caps are not necessary, but if you do, I suggest printing the ones marked "tight." You will need:M4x14 screws - 4 piecesStandard M4 nuts + widened washers - 4 setsor M4 flange nuts - 4 pieces (I used these)Original or similar (printed) Qbrick connectors - 2 piecesYou can use your own print settings, but mine are as follows:PETG filamentWalls: 6Bottom and top layers: 5Infill: 100%Supports: YES, standard (there aren't many and they're easy to remove), you can use a deburrer.Brim - at your discretionIroning the last layer - not necessary.The 3mf