Thingiverse
QI wireless mobile charger
von blackbird2016
2
Downloads
3
Likes
0
Makes
Use some flexible material for the ring which is interlocking with the top part after one got it pressed in the recess. I recommend only 3 bottom layers and 5% infill.
The housing print in whatever you like without any supports. (the top upside down)
For me it was PETG Vertigo Gray.
The duct is for 3mm usb cables.
The housing print in whatever you like without any supports. (the top upside down)
For me it was PETG Vertigo Gray.
The duct is for 3mm usb cables.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
