QIDI BOX - filament feeder case replacement

I had an issue with the QIDI BOX clutch mechanism on one of the spool holder slots where it would not reel in the spool when retracting the filament.

I discovered this was because the cover over the motors was putting pressure on one of the motor assemblies. This resulted in too much pressure between the cogs of the motor assembly and the clutch. Removing the cover resolved this issue. As an added bonus, by removing this cover, we also gain easy access to the filament feeder mechanism when/if a filament fragments jam into the sensor switch.

The filament feeder caps protect the exposed electronics for each motor assembly. It clips on to the top of the assembly and is fastened using the bolt from the top left hand side.