Thingiverse
QIDI Plus4 LCD blank
por tpanther
14
Descargas
9
Likes
0
Makes
After trying a small blank that covers the hole for the lcd wiring and not liking( as it would fall into the printer) it I made this completely over the top one which fills in around the entire lcd.
Print out of TPU for easiest fitment.
It slides in at the top where the thickest side is. then you stretch the thinner part around the bottom, push it into place a bit and it fills the gap lovely. If using a stiff plastic instead you may have to remove the LCD and reinstall it over the top of print.
5% honeycomb infill, 2 walls. .2 layer height
Print out of TPU for easiest fitment.
It slides in at the top where the thickest side is. then you stretch the thinner part around the bottom, push it into place a bit and it fills the gap lovely. If using a stiff plastic instead you may have to remove the LCD and reinstall it over the top of print.
5% honeycomb infill, 2 walls. .2 layer height
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
