Qidi Q1 Pro Extra Improved Lid Riser

The Q1 Pro lid riser remix by DoriansCurse is functionally perfect, but I dislike the sharp edge left on the outside of the print which was in the original by Ragnars0n. Additionally the corners were sharp 90 degrees rather than following the radius of the recess in the top of the printer. This fixes these issues.
I printed this in TPU but PETG should be fine. I wouldn't recommend PLA if you are going to use the chamber heating.

08-06-2025 Radiused outside upper edge, improves appearance and uses a little less material.