Thingiverse
Qidi X-One LED Switch Box
por BrayChristopher
41
Descargas
28
Likes
1
Makes
The LED's in the Qidi Tech X-One printer are always ON when the printer is on. There is no way to turn them off.
I don't need the LED's on while I am asleep, so I installed a toggle switch.
I really wanted a rocker switch, but the hardware store only had toggle switches. So I ended up with an ugly toggle switch from the 1950's.
The housing mounts onto the threaded posts that used to hold the cable clips on. The housing has a little cut out in the corners to allow the cables to enter and exit.
I didn't have a nut driver for the M3 nuts, so I made one: https://www.thingiverse.com/thing:2454748
I might reprint this in a temperature resistant material someday.
I don't need the LED's on while I am asleep, so I installed a toggle switch.
I really wanted a rocker switch, but the hardware store only had toggle switches. So I ended up with an ugly toggle switch from the 1950's.
The housing mounts onto the threaded posts that used to hold the cable clips on. The housing has a little cut out in the corners to allow the cables to enter and exit.
I didn't have a nut driver for the M3 nuts, so I made one: https://www.thingiverse.com/thing:2454748
I might reprint this in a temperature resistant material someday.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
