Thingiverse
QIDI X-PLUS 3 TOP LID RISER
door KeiEich
14
Downloads
18
Likes
0
Makes
Lift the top lid 40mm.
I made this so that I could leave the top lid on while printing PLA.
Compared to completely removing the top cover, the internal temperature will rise by about 4 degrees Celsius. I recommend leaving the front door open.
0.2mm layer hight.
no support.
If printing does not work, flip it upside down and print with support.
I made this so that I could leave the top lid on while printing PLA.
Compared to completely removing the top cover, the internal temperature will rise by about 4 degrees Celsius. I recommend leaving the front door open.
0.2mm layer hight.
no support.
If printing does not work, flip it upside down and print with support.
KeiEich publiceert ook op
16 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
