Thingiverse
Qidi Xplus-3 side spool holder
di Dypsyprinter
0
Download
1
Likes
0
Makes
Side spool holder and filament sensor relocation.Printed from standard PLA, glued CA glue.
Material: two screws m6x30 din 603, two nuts m6 din 934, one screw m8x40 din 933 (stick in part 01b), one nut m8 din934 (stick in part 03a), 8 neodymium magnets diameter 6 x 6 mm height.
FESTO Screwing with a plug end QSM-M5-4 code 153304 (thread M5 for tube diameter 4mm) or similar from SMC,Aliexpress...
Foil for two windows: some hard foil from some package. I used the rest of the durofol 0.4mm foil.
Moving the sensor of the end of the filament to a new position. For a smooth approach, we knock down the inner edge of the ptfe tube facing the extruder.
The cable is original, but there is a groove filed in the upper right corner of the castle to allow the length to come out..
Material: two screws m6x30 din 603, two nuts m6 din 934, one screw m8x40 din 933 (stick in part 01b), one nut m8 din934 (stick in part 03a), 8 neodymium magnets diameter 6 x 6 mm height.
FESTO Screwing with a plug end QSM-M5-4 code 153304 (thread M5 for tube diameter 4mm) or similar from SMC,Aliexpress...
Foil for two windows: some hard foil from some package. I used the rest of the durofol 0.4mm foil.
Moving the sensor of the end of the filament to a new position. For a smooth approach, we knock down the inner edge of the ptfe tube facing the extruder.
The cable is original, but there is a groove filed in the upper right corner of the castle to allow the length to come out..
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
