Qiditech frame edge and oversize test

This is a frame test for Qiditech and other 150 x 230 bed printers. After downloading the test file you will have to set the model axes to set the frame to the bed edges as the model is over sized to most slicers and will probably not centre automatically. It will put a stripe around the theoretical edge of your print area at the 150 x 230 marks. It will then start to build "T" towers at a 30 degree angle over the edge of the bed. You should not let it finish the print as it will be causing the belts to jump after about half way up the tower. You can then see how much you can overprint if you need to on a large print. If you know how to put off angle supports on an object overhanging edge of the printer it is a very useful amount to know. Also just FYI. You will note that using the left nozzle will let you overhang more on the front and left. The right nozzle will give you more on the right and front.
The cant on the T towers part way up is caused by the other axis hitting it's s