Qimsi PCB

First, I must state, I do not own a Qimsi. The design is only made from scale pictures from the manual and from the case design online. This STL will hopefully aid in the design of creating such cases for this hardware. The hangovers on the rear are 2mm, so if your case is 2mm or less, this will cut out the holes in the right places. The SDcard slot does not protrude from the PCB, but this is where the hole is cut out on the case, thus this *should* line up (yes there are a lot of maybes involved here) and this is why I have protruded this from the rear to help with a cut out. The small square between the SDcard cutout and the first 'USB' (I use the term USB very loosely) is where the LED would be. The three holes to the right hand side of the PCB are for a serial port if required.